2022年9月1日星期四

Induction Brazing Brass Studs to Copper Pipes

Induction Brazing Brass Studs to Copper Pipes
Objective:

Induction brazing brass studs to copper pipes

The Client:

A manufacturer of coils for industrial heating applications.

Equipment:

DW-UHF-40KW Induction Brazing Systems – two modules.

Materials: Brass stud ( size:  25mm diameter, 20 mm height ) Power: 30 kW
The Process:  The main challenge during this induction brazing process is to ensure that the design of the coil is one that eases the technician to position it in the most convenient way. The induction coil should allow for the second stud to be pre-heated without melting the first one. First, the electrolytic copper section is wound on a steel former by a gas torch while an equal spacing between the turns is maintained. Then, the copper turn is heated close to the required temperature and while the power is ON, the technician should make sure to manually position the brass stud with the brazing ring at the designated centre. During the process of brazing, the induction coil is moving at a speed of 58 mm per minute – 33 kW. If the power is increased, the speed changes accordingly. Results and Conclusions:
  • A fast, clean and safe induction brazing process
  • Guaranteed repeatability
  • Precise control of time and temperature

关注者

博客归档

我的简介

我的照片
HLQ induction heating machine manufacturer provides the service of induction brazing,melting,hot forming,hardening surface,annealing,shrink fitting,PWHT,etc.