Objective
Induction Soldering coaxial cable to connector ring and pin in two steps in under 5 seconds by reaching a temperature of 500°F (260°C) with induction heating.
Equipment
DW-UHF-6KW-I handheld induction Soldering Heater
Materials
• No-flux solder wire
• Coaxial cable
• Cable connector
• Center pin
Key Parameters
Power: 1.0kW
Temperature: 662°F (350°C)
Time: 5 sec
Process:
- The coaxial cable and connector were placed vertically inside the coil.
- Induction heating was applied for 3 seconds, at which point the part is hot enough for soldering.
- The soldering wire was fed between the cable braid and connector.
- Solder wire was inserted into the center pin, and the center pin was placed in the coil.
- The cable with connector was placed above the pin.
- Induction heating was applied for 1.5 seconds, after which the part was hot enough for soldering.
- The center conductor was inserted into the pin.
- The assembly was inspected to ensure that the induction soldering was successful.
Results/Benefits:
- Strong durable joints and faster heating cycles
- Selective and precise heat zone, resulting in less part distortion and joint stress
- Technology without pollution, which is both clean and safe
https://dw-inductionheater.com/wp-content/uploads/2020/04/Soldering-Coaxial-Cable-to-Connector.png?v=1585816549
https://dw-inductionheater.com/induction-soldering-coaxial-cable-to-connector-ring.html
cable induction soldering, high frequency soldering, high frequency soldering cable, high frequency soldering machine, induction soldering coaxial cable, induction soldering machine, RF soldering cable, RF soldering machine, RF soldering system, Soldering Coaxial Cable
