Induction Soldering Cables to Terminals

Objective
Induction Soldering cables to terminals in under 20 seconds using induction.

Equipment
DW-UHF-6KW-I handheld induction heater

Materials
• 0.078″² (50mm²) cable terminal

• 0.078″² (50mm²) cable

• Soldering alloy Sn60Pb38Cu2

Key Parameters
Power: 2.8 kW

Time: 15-20 sec

Temperature: 500° F (260° C)

Process:

1. The 0.078″² (50mm²) cable terminal is attached to 0.078″² (50mm²) cable


2. The assembly is positioned inside the coil and induction heating is applied.


3. Time to temperature is about 4 -5 sec. The temperature is maintained constant to complete the soldering process. A foot switch is used to start and stop the machine.


4. After 15-20 sec, the cable and cable terminal are successfully soldered.

Results/Benefits:
Suitable induction heating systems for the process:

DW-UHF-6KW-I handheld induction heater

The DW-UHF-6KW-I handheld induction heater will require a longer time to reach temperature and complete soldering.

Induction heating provides:

• Strong durable joints


• Selective and precise heat zone, resulting in less part distortion and joint stress


• Less oxidation


• Faster heating cycles


• More consistent results and suitability for large volume production, without the need for batch processing


• Technology without pollution, which is clean and safe

https://dw-inductionheater.com/wp-content/uploads/2020/04/Induction-Soldering-Cables-to-Terminals-2-1.png?v=1585812073
https://dw-inductionheater.com/induction-soldering-cables-to-terminals.html
high frequency soldering cables, induction solder, induction soldering cables, Induction Soldering Cables to Terminals, induction soldering heater, induction soldering machine, RF soldering cables, soldering cables, soldering machine, ultra high frequency soldering cables