Induction Soldering Cables to Terminals

Objective Induction Soldering cables to terminals in under 20 seconds using induction.

Equipment DW-UHF-6KW-I handheld induction heater Materials • 0.078″² (50mm²) cable terminal • 0.078″² (50mm²) cable • Soldering alloy Sn60Pb38Cu2 Key Parameters Power: 2.8 kW Time: 15-20 sec Temperature: 500° F (260° C)

Process:

1. The 0.078″² (50mm²) cable terminal is attached to 0.078″² (50mm²) cable
2. The assembly is positioned inside the coil and induction heating is applied.
3. Time to temperature is about 4 -5 sec. The temperature is maintained constant to complete the soldering process. A foot switch is used to start and stop the machine.
4. After 15-20 sec, the cable and cable terminal are successfully soldered.

Results/Benefits: Suitable induction heating systems for the process: DW-UHF-6KW-I handheld induction heater The DW-UHF-6KW-I handheld induction heater will require a longer time to reach temperature and complete soldering. Induction heating provides:

• Strong durable joints
• Selective and precise heat zone, resulting in less part distortion and joint stress
• Less oxidation
• Faster heating cycles
• More consistent results and suitability for large volume production, without the need for batch processing
• Technology without pollution, which is clean and safe

https://dw-inductionheater.com/induction-soldering-cables-to-terminals.html?feed_id=222061&_unique_id=64cfcb94cb0b1