2022年12月24日星期六

Induction Shrink Fit Aluminum Shaft

Induction Shrink Fit Aluminum Shaft with IGBT induction heating systems Objective Heat aluminum impeller blades to 200 ºF (93 ºC) and shrink fit onto a shaft. Material Aluminum impeller blades with a .28” (7.109mm) bore, aluminum shaft Temperature 200 ºF (93 ºC) Frequency 255 kHz Equipment • DW-UHF-6W induction heating system, equipped with a remote workhead containing one 1.0μF capacitor. • An induction heating coil designed and developed specifically for this application. Process A split two turn helical coil is used to evenly heat the opening on the impeller blade. The impeller blade is heated for 20 seconds to reach the 200 ºF (93 ºC). The impeller blades are then removed from the coil & slipped over the shaft to complete the shrink fitting application. Results/Benefits Induction heating provides: • Repeatable results • Reduced cycle time, lower consumables cost • Even distribution of heating Shrink Fit Aluminum                 Shrink Fit Aluminum with induction

关注者

博客归档

我的简介

我的照片
HLQ induction heating machine manufacturer provides the service of induction brazing,melting,hot forming,hardening surface,annealing,shrink fitting,PWHT,etc.